Installation
4
5
Before installing your new mixer, flush
through the pipework to ensure removal
of debris, turn off the water supply.
Screw the two flexible pipes to the mixer
body, do not over tighten.
Screw the threaded rod into the front
hole in the base of the mixer body.
Ensure the seal is in place in the bottom
of the mixer body.
Position the mixer on the basin. From
the underside of the basin fit the rubber
washer onto the threaded rod followed
by the metal washer and the nut.
Tighten the nut to clamp the mixer to
the basin.
CAUTION:
Do not over tighten the nut
as this may damage the basin.
Connect the water supply to the
inlet pipes. The hot water should be
connected to the left hand pipe.
Seal
Metal washer
Threaded
rod
Nut
Flexible pipes
Control
handle
Aerator
Rubber washer
Push waste assembly and installation
(supplied with CC body only)
Plug
Base seal
Waste body
Waste flange
Disassemble the push waste, unscrew
the waste flange from the flange nut.
Slide the flange seal over the thread of
the waste flange.
Place the waste flange with seal through
the hole in the basin.
From beneath place the base seal over
the thread of the waste flange and then
screw on the flange nut until tight.
CAUTION:
Do not over tighten as this
may damage the parts and/or the basin.
Flange seal
