12
Installation
Insert the spacer plate into the step of the
collar.
There is a spacer plate incorporated into the end of the tiling guide. Remove this by
snapping it at the four points. Remove any burrs.
Tiling guide
Spacer plate
Step of collar
Extension rod
Spacer plate
Screw the extension rod onto the spindle
of the cartridge.
13
Installation
Measure the distance
(X mm)
the rod protrudes from the level of the spacer plate
and then unscrew the rod and remove the spacer plate.
Note:
Ensure the cartridge is
pushed in (the off position).
X mm
X mm
Rod
Spacer plate
Extension rod
Cap
Hex key
Screw the cap onto the rod until it's flush
and tighten the grub screw on the cap
using the smaller hex key provided with
the ZON-128.
Cut away the measured distance
from the end of the rod as well as the
2 screws
provided with the ZON-143 trim.
(X mm)