6
7
Installation
Before installing your new mixer, flush
through the pipe work to ensure removal
of debris, turn off the water supply.
Ensure the O-ring is in place in the
bottom of the mixer body.
Position the mixer on the basin. From
the underside of the basin screw the
two flexible pipes to the hot and cold
connections in the mixer body, the hot
should be to the left and the cold to the
right, hand tighten only.
Screw the threaded rod into the small
hole inside the mixer body.
Slide the rubber and metal washer over
the rod, the rubber washer should be
on top. Screw on the nut and tighten to
clamp the mixer to the basin.
CAUTION:
Do not over tighten the nut as
this may damage the basin.
Connect the water supply to the inlet
pipes. The hot water should be connected
to the left pipe and cold to the right.
CAUTION:
When
installing the
flexible hoses
do
not
kink, or bend
them more than the
60mm diameter as
shown right.
60mm
3
4
5
1
2
3
4
0 5
1
2
3
4
0 5
1
2
3
4
0 5
1
2
3
4
0 5
1
2
3
4
0 5
1
2
3
4
0 5
Installation - Quick guide
Clic-Clac
Control
handle
O-ring
Rubber
washer
Metal
washer
Nut
Hot flexible
pipe
Cold flexible
pipe
Threaded
rod
