6
7
Installation
CAUTION:
When
installing the
flexible hoses
do
not
kink, or bend
them more than the
60mm diameter as
shown right.
60mm
Installation - Quick guide
4
5
3
1
2
3
4
0 5
1
2
3
4
0 5
1
2
3
4
0 5
1
2
3
4
0 5
1
2
3
4
0 5
1
2
3
4
0 5
Before installing your new mixer, flush
through the pipe work to ensure removal
of debris, turn off the water supply.
Ensure the O-ring is in place in the
bottom of the base ring. Place the base
ring onto the bottom of the mixer body.
Position the mixer on the basin. From
the underside of the basin screw the
two flexible pipes to the hot and cold
connections in the mixer body, the hot
should be to the left and the cold to the
right, hand tighten only.
Screw the two threaded rods into the
small holes inside the mixer body.
Slide the rubber and metal washer over
the rods, the rubber washer should be
on top. Screw on the nuts and tighten to
clamp the mixer to the basin.
CAUTION:
Do not over tighten the nuts as
this may damage the basin.
Connect the water supply to the inlet
pipes. The hot water should be connected
to the left pipe and cold to the right.
Control
handle
Base ring
O-ring
Rubber
washer
Metal
washer
Nut
Hot flexible
pipe
Cold flexible
pipe
Threaded
rods
