WallVIEW HD-18 DVI/HDMI
©2011 Vaddio - All Rights Reserved. WallVIEW HD19 DVI/HDMI, Document Number 342-0045 Rev. C
Page 9 of 16
Step 3: SECURE THE CAMERA TO THE CONCEAL WALL MOUNT BRACKET:
After all cables are attached to the camera, place the camera onto the camera mount and insert the two-
(1/4”-20) screws into the camera through the two-screw holes in the bottom of the mount.
Note:
Be sure to align each side of the camera evenly to all sides of the CONCEAL Wall Mount Bracket
before final tightening of the mounting screws (see Fig. 2).
Step 4: INSTALL THE CONCEAL LOWER COVER PLATE:
Attach lower CONCEAL Lower Cover Plate (see Fig. 3). Slide lower cover plate from front of the
mounting bracket toward the rear of the bracket. The two-rear locking tabs will need to be guided into
position first and will lock in place as the lower cover plate is pushed toward the rear of the mounting
bracket and the front tabs are inserted (see Fig. 4).
Step 5: CONNECT POWER AND TEST:
Connect the 24VDC, 2A power supply to the Quick-Connect and plug it into the wall once all the
connections have been checked. The camera will “HOME” to a centered position. To ensure proper
continuity of control and operation of the cameras, the RS-232 controller (control system, codec or
joystick) should be powered ON after all of the cameras.
Note: Plugging the EZCAMERA POWER & HD VIDEO Cat 5e cable into the wrong
RJ-45 may cause damage to the camera system and void the warranty
.
Step 6: INSTALL THE CONCEAL REAR CAMERA COVER:
After successful testing of the camera, install the Conceal Rear Camera Cover on the CONCEAL
Mounting Bracket with the supplied screw (see Fig. 5 and 6).
Fig. 2:
Vaddio HD-18 Camera aligned
and attached to the CONCEAL Wall
Mount Bracket
Fig. 3:
CONCEAL Lower Cover Plate
with Locking Tabs
Fig. 4:
CONCEAL Lower Cover Plate
locked in place
Fig. 5:
CONCEAL Rear Camera Cover
Fig. 6:
Completed CONCEAL Wall
Mount Camera Bracket Installation