Back of the Camera – RoboSHOT 12 HDMI and RoboSHOT 30 HDMI
Rear panel connectors are identical for the older RoboSHOT 12 HDMI and RoboSHOT 30 HDMI cameras.
From left to right:
n
Network:
RJ-45 connector. Connect to the network for control via the web interface or Telnet session.
n
HD Video Select:
Rotary switch to select the video output resolution. See
n
Camera Settings:
DIP switches to set camera behaviors such as IR frequency, image flip (camera is
invertible), and baud rate. See
Camera Behavior Settings – RoboSHOT 12 HDMI and RoboSHOT 30
for more information.
n
RS-232:
RJ-45 connector. Allows an external device to manage the camera using a modified VISCA
protocol. See
RS-232 Serial Communication Settings
n
HDMI:
HDMI video output connector.
n
12 VDC, 3.0 A:
EIAJ-04 jack for local power. Connect only the power supply shipped with the camera
or approved replacement 12 VDC, 3A power supply. This connection is not needed if you use a
OneLINK device.
Note
A label on the bottom of the camera lists the rotary and DIP switch settings.
10
Installation Guide for RoboSHOT HDMI High-Definition PTZ Cameras
