IN-Wall Enclosures
Face Frame
attached to
back box with
four screws
Camera
Platform
attached to
Back Box with
four Screws
Face Frame
(rear view)
Deep Back Box Enclosure
The 3-15/16” deep metal wall box uses the maximum depth of a standard 2” x 4” framed wall cavity and minimizes the camera’s
protrusion into the room. Each Enclosure is outfitted with three (3) conduit knockouts (2-sides, 1-top) and a cable pass-through
in the back box and camera platform.
Before Installing
When locating the IN-Wall enclosure, consider viewing angles, lighting conditions, possible line of site obstructions and
check
for in-wall obstructions where the camera is to be mounted
(like studs). Pick a mounting location to optimize the
performance of the camera. Please read the step-by-step instructions fully before starting the installation.
INSTALLATION INSTRUCTIONS:
1)
Position the back box enclosure against the wall, level the box and trace the outline
of the box on the wall with a pencil.
2)
After checking for in-wall obstructions, cut out the area marked on the wall with a
drywall saw.
3)
Place the enclosure into the wall opening for a dry fit and mark the four holes for
the spiral wall anchors through the mounting flanges. The integrator can use any
wall anchor of their choice or use the supplied wall anchors. Level the back box.
Remove the back box and install the wall anchors. Pull the cabling through the
wall and back box and push it into the opening. Fasten the enclosure to the wall
with wall anchors.
4)
On the sides of the face frame, there are four holes (see drawing below) for
attaching the Face Frame to the Back Box with the supplied white pan head
machine screws.
5)
Place the Camera Platform onto the bottom of the Back Box, and screw the
platform down with the four flat head machine screws. If using the cable
pass-through, thread the cables through the platform.
6)
Connect the camera system and push the slack in the cabling back into the
wall.
7)
Place the camera on the Camera Platform and secure the camera to the
platform with the supplied screws
HARDWARE WARRANTY:
Please see the Vaddio website at
support.vaddio.com
for the Vaddio Statement of Warranty for all Vaddio Products. The
Statement of Warranty covers the policies and procedures of the Hardware Warranty, Exclusions, Customer Service, Technical
Support, Return Material Authorizations (RMA), Voided Warranty, Shipping, Handling and Products Not Under Warranty. The
Vaddio Warranty Statement supercedes all other published warranty statements heretofore in content and coverages. Vaddio
Technical Support can be contacted through the Vaddio website or through e-mail support at
.
EZIM
Mounting
Nuts X 2
Use a level to position the enclosure and trace a line
around the back of the enclosure once the box is level.
Toll Free: 1-800-572-2011, Main: 763-917-4400, FAX: 763-971-4464, vaddio.com
©2014 Vaddio - All Rights Reserved. Reproduction in whole or in part without written permission is prohibited. Specifications and pricing are subject to change without notice or
obligation. Vaddio, IN-Wall, RoboSHOT, ClearVIEW, PowerVIEW and WallVIEW are trademarks of Vaddio. All other trademarks are property of their respective owners. Planet
HD-189733b in front page header courtesy of Hubble Space Telescope, Document Number 341-744 Rev F, SD: 68314.1
Four Screw holes
for mounting the
Face Frame to the
Back Box
