Edge Equipment Enclosures
. Edge Equipment Enclosures - Document Number 342-0026 Rev. A
Page 7 of 12
4)
Enclosure Assembly
a. Lay the enclosure bottom on a flat, clean surface with the connecting posts up as shown
below (a).
b. Slide one side onto the connecting post. Make sure the groove in the side matches the
groove in the bottom at the back of the bottom shown in (b).
c. Turn the three cams clockwise until they lock, (about a half turn) as shown in (c).
d. Insert back into groove in side and bottom as shown below (d). Make sure the brown clips
are on the out side of the enclosure. Repeat step b and c for other side as shown in (e).
e. Match the connecting posts of the top with the sides and slide together as shown below (f).
Turn all 6 cams clockwise to tighten down the top to the sides. Make sure all cams are tight.
⒜
⒝
⒞
⒟
⒠
⒡
