VADDIO DocCAM 20 HDBT, Руководство по установке

Страница: 12 / 18

Powering Up the Camera
Connect power to the OneLINK device or mid-span power injector that supplies power and connectivity to
the camera.
The camera will take a few seconds to initialize. When the camera is ready, its status light is blue. At this
point, video is available and the camera is ready to accept control information.
Caution
This product contains a 5 mw, 650 nm red laser which produces visible laser radiation. Avoid direct eye
exposure. Do not look at the laser aperture during camera operation.
Caution
Laser controls are available to remote operators using the web interface. Keep your eyes out of the beam
path when the camera is connected to power.
Note
Wait until the camera finishes initializing before trying to operate or control it.
Status Light
The light in the camera's face indicates its current state.
Caution
This product contains a 5 mw, 650 nm red laser which produces visible laser radiation. Avoid direct eye
exposure. Do not look at the laser aperture during camera operation.
Caution
Laser controls are available to remote operators using the web interface. Keep your eyes out of the beam
path when the camera is connected to power.
n
Blue: Normal operation (blinks off momentarily when the camera receives a command from the remote)
n
Purple: In standby mode or booting
n
Yellow: Firmware update in progress
Next Steps
The camera is now ready to configure and use. This information is available in the Configuration and
Administration Guide for the DocCAM 20 HDBT Ceiling-Mounted Document Camera . It is also
included in the Integrator's Complete Guide to the DocCAM 20 HDBT Ceiling-Mounted Document
Camera .
10
Installation Guide for the DocCAM 20 HDBT Ceiling-Mounted Document Camera