vacuubrand VACUU-PURE 10, Инструкция по эксплуатации

Страница: 22 / 88

22 20901220_EN_VACUU·PURE 10_V1.6_060722
Safety information
Overheating
Hazards due to overheating
The vacuum pump can be damaged due to overheating. Possible
causes include insufficient air supply to the fan, failure to maintain
minimum distances, ambient temperature outside the specified
operating conditions. Overheating of the vacuum pump can lead
to a reduction in the speed of the vacuum pump or to the vacuum
pump being switched off.
>
When installing the product, ensure that there is a minimum
distance of 5 cm between the vacuum pump and adjacent
parts (such as the housing, walls, etc.).
>
Always ensure that there is a sufficient air supply and air
extraction to remove the warm exhaust air from the vacuum
pump, especially if the vacuum pump is installed in a housing
or lab furniture. Provide external forced ventilation.
>
Place the product on a stable surface. A soft surface such as
foam rubber can impair and block the air supply.
>
Clean polluted ventilation slots.
>
Avoid excessive heat input due to hot process gases.
>
Observe the maximum admissible media temperature

see chapter:
8.1.1 Technical data on page 70 8.1.1 Technical data on page 70
.
>
Allow the vacuum pump to cool down before servicing or
cleaning.
Keep signs legible
Keep any signs affixed to the product in an easily readable
condition:
>
Labels
>
Warning and information signs
>
Rating plates
Labels and signs