3. Insert both front support tabes into base
slots. Then snap brush supports into place.
Front
Support Tab
4. Line up tabs on front of base with slots
inside the cover front.
5. Tilt cover to back. Press cover firmly until rear
tabs snap into place. Turn EB-210 SuperGroom
II™ over, replace the cover screws and lower the
pile height adjustment rollers into place.
BRUSH SERVICING
EB-210 SuperGroom II™:
Disconnect hose and brush from electrical outlet
and disconnect EB-210
SuperGroom II™ from wand so brush will not operate while being serviced.
To Check:
When brush is worn to the level of the base
support bars, replace the brush.
Base Support Bar
Rear
Base
Tabs
Cover
Slots
Front
Base Tabs
To Replace:
Remove light cover, EB-210 SuperGroom II™
cover, belt and brush assembly (follow to remove
section in Belt Changing and Brush Cleaning”.
7
1. Remove brush support and washers from brush assembly.
2. Remove brush assembly and replace with new brush.
3. Reassemble brush assembly.
4. Replace belt, brush assembly, EB-210 SuperGroom II™
cover.
Please note when ordering that you must include the identification number for
the brush. For the EB-210 SuperGroom II™ this is EB210 (i.e. to order a light
bulb you would order an EB21016).
-10
Belt
-11
-12
Floor nozzle lower unit
-13
Motor assembly
-14
Motor bracket
-15
Overload protector
-16
Light bulb
-17
Light bulb socket
-18
Swivel catch
-19
Swivel
-20
Furniture guard
-21
Roller shaft
-22
Swivel bearing seal
-23
Nozzle roller
-24
-25
-26
Front axle assembly
-27
Brush and bearing assembly
-28
-29
Window cover (not shown)
-30
-31
-32
Cord and plug assembly (not shown)
-33
Power head cover assembly (not shown)
-34
Floor nozzle upper unit (not shown)
EB-210 SuperGroom II™ Parts List
8
L6178
