Vacon NXI, Руководство пользователя

Страница: 55 / 105

cabling and connections vacon • 55
24-hour support: +358-(0)40- 8371 150 • Email: vacon@vacon.com
6
6.2.2 Control terminal signals
Terminal Signal Technical information
1 +10 Vref Reference voltage Maximum current 10 mA
2 AI1+ Analogue input,
voltage or current
Selection V or mA with jumper block X1 (see page
58):
Default: 0– +10V (Ri = 200 k Ω )
(-10V…..+10V Joy-stick control, selected with a jumper)
0– 20mA (Ri = 250 Ω )
3 GND/AI1– Analogue input common Differential input if not connected to ground;
Allows ± 20V differential mode voltage to GND
4 AI2+ Analogue input,
voltage or current
Selection V or mA with jumper block X1 (see page
58):
Default: 0– 20mA (Ri = 250
Ω
)
0– +10V (Ri = 200 k Ω )
(-10V…..+10V Joy-stick control, selected with a jumper)
5 GND/AI2– Analogue input common Differential input if not connected to ground;
Allows ± 20V differential mode voltage to GND
6 24 Vout
(bidirectional)
24V auxiliary voltage ± 15%; maximum current 250 mA all boards total; 150
mA from single board. Can also be used as external
power backup for the control unit (and fieldbus).
7 GND I/O ground Ground for reference and controls
8 DIN1 Digital input 1
R
i
= min. 5k
Ω
18…30V = "1"
9 DIN2 Digital input 2
10 DIN3 Digital input 3
11 CMA Digital input common A for
DIN1, DIN2 and DIN3. Must be connected to GND or 24V of I/O terminal or
to external 24V or GND
Selection with jumper block X3 (see page 58):
12 24 Vout
(bidirectional)
24V auxiliary voltage Same as terminal #6
13 GND I/O ground Same as terminal #7
14 DIN4 Digital input 4
R
i
= min. 5k
Ω
18…30V = "1"
15 DIN5 Digital input 5
16 DIN6 Digital input 6
17 CMB Digital input common B
for DIN4, DIN5 and DIN6 Must be connected to GND or 24V of I/O terminal or
to external 24V or GND
Selection with jumper block X3 (see page 58):
18 AO1+ Analogue signal (+output) Output signal range:
Current 0(4)–20mA, R
L
max. 500 Ω or
Voltage 0—10V, R
L
>1k Ω
Selection with jumper block X3 (see page 58):
19 AO1– Analogue output common
20 DO1 Open collector output Maximum U
in
= 48VDC
Maximum current = 50 mA
Table 6
-
10. Control I/O terminal signals on basic I/O board OPT-A1