Vacmaster VQ1030SIWDC-110, Оригинальное руководство пользователя

Страница: 10 / 20

10
GB
UNPACKING AND CHECKING CARTON
CONTENTS
ASSEMBLY
NOTE: A Phillips screwdriver is required.
1. Remove all the contents from inside of the vacuum cleaner container.
2. Attach the carry handle into the slots located on the top of the power head (Fig. 1).
3. Turn the container upside down and insert the front feet with casters into the slots and apply
pressure until they click into place (Fig. 2).
4. Insert the wheel axle into the rear wheel housing on the base. Insert a washer onto the axle
followed by the rear wheel and another washer. Insert the wheel retaining pin into the hole on
the end of the axle to lock into place. Push fit the hub cap onto the wheel. Repeat the same
steps on the other end of the axle (Fig. 3).
5. Your vacuum cleaner comes ready for dry vacuum cleaning with the cartridge filter and pre-filter
pre-installed. If the cartridge filter and pre-filter are not installed, refer to page 12.
6. Optionally, for improved dust filtration, fully fit the dust bag flange onto the inlet stub (Fig. 4).
1 Carry Handle 17 Round Dust Brush
2 On/Off Switch 18 Foam Filter
3 Latch 19 Dust Bag
4 Rear Wheel 20 Crevice Tool
5 Front Caster 21 Hard Floor Nozzle
6 Drainage Port 22 HEPA H13 Cartridge Filter (pre-installed)
7 Container 23 Filter Retainer (pre-installed)
8 Suction Port 24 Pre-filter
9 Power Take-off Socket 25 Metal Accessory Adaptor
10 Power Head 26 Washer (x4)
11 Power Cable Hook 27 Hub Cap (x2)
12 Accessory Storage 28 Wheel Retaining Pin (x2)
13 Blowing Port 29 Wheel Axle
14 Suction Hose 30 Screw (x2)
15 Power Tool Hose Adaptor 31 Instruction Manual
16 Extension Wand (x3)