Power Head
Cord Retainer
Vacuum Port
On-Off Switch
Container
Main Handle With Soft Grip
Caster
Handle
Latch
Hose Holder Base
Accessory Shelves
Wheel
Drain
Outlet-Socket
*
G
ENERAL ASSEmBLY INStRUctIONS
WARNING:
Do noT plug In poWEr CorD To poWEr ouTlET, maKE SurE
plug IS DISConnECTED bEforE aSSEmblIng THE WET/Dry VaC
UNPAcKING YOUR WEt/dRY vAcUUm & GENERAL ASSEmBLY
1. Undo the latches. (As show in fig.2)
2. Lift the power head off the container. (fig.3)
3. Remove the contents from inside the container, make sure you have all contents as
listed on page10-11. (fig.4)
4. With the power head removed, turn the container upside down. Insert the two
casters into the socket on the bottom of the base and tighten each caster with
2 screws.(fig.5)
5. Insert the rear wheel shaft (Q) into the rear support block. Insert washer (P) on
the shaft, then insert rear wheel (N) on the shaft. Insert the ‘R’ lock pin (O) into the
hole on the end of the shaft to lock the wheel. Snap the hub cap (S) on to the
wheel. Repeat the same steps at the other end of the shaft. Please notice you must
install the hub cap on to the wheel , otherwise the ‘R’ lock pin will come loose and
cause the wheel do not work .(fig. 6)
6. For wet vacuum cleaning, install the supplied foam filter. (fig. 7) See page 9 for
filter installation.
7. Your vacuum comes ready for dry vacuum cleaning with PET cartridge filter pre-
installed. If cartridge filter is not installed, refer to page 9 for filter installation.
(fig. 8 & fig. 9)The PET cartridge filter fit for wet & dry vacuum cleaning.
8. Put the PRE cloth filter over the filter tray with the attached PET cartridge filter.
(fig.10)
9. Optional, for improved dust filtering, fit collection bag flange onto the inlet stub,
taking care not to damage the bag. (fig.11)
10. Place the power head back on the container, and secure it by using the 2 side
latches. (fig.12&fig.13)
11. Insert the push handle into the handle sockets mounted on the sides of the tank.
Push down until the lock pin clicks in place. (fig.14)
12. Remove the drain cover first and secure the large end of the drain hose onto the
vacuum drain by screwing into place. (fig.15a) Hang the drain hose by inserting
into hose holder base.(fig.15b) Make suer drain lid is closed.
*only aVaIlablE
for VmVK1660SWDC
