9
Using Your Pump Accessory
WARNING:
To reduce the risk
of fi re or electric shock, do not
run vac unattended.
!
Turn on the unit by pushing the switch
from position “O” to position “l”. The
symbols used on the switch actuator are
international “On & Off” symbols.
“O” is the symbol for “OFF” and “l” is
the symbol for “ON”.
O = OFF I = ON
Your Pump Accessory will work best
when being used to pump large
amounts of liquid. If the liquid does not
fi ll the drum so that it covers the drain
on the inside of your Wet/Dry Vac, the
pump may not function properly. Due
to the function of Wet/Dry Vac and the
Pump Accessory, the pump will not
operate properly if your vac is running.
1. Make sure that your pump is
connected to the drain of your vac
(See Assembly), and that the GFCI is
functioning properly. If you require
a hose, connect it to the outlet of the
pump.
2. Close the shut-off valve and vacuum
up the intended liquid until your
Wet/Dry Vac stops picking up the
liquid or until all liquid is cleaned up.
3. Turn your vac off, allowing it to stop
completely. Position hose to the
desired location to empty drum
5. To verify drum is mostly empty,
unplug the pump and vac, remove
vacuum powerhead and inspect the
drum contents. If liquid is still in
drum, see “Troubleshooting” section
on page 11.
NOTE: Do not run pump dry or damage
may occur to internal components of
the pump and void warranty.
6. Unplug the pump, unplug and
remove the powerhead of your
Wet/Dry Vac and clear any debris
that may have collected on or near
the strainer of the pump. Reinstall
the power head and repeat steps 2
through 5 as required.
contents. Open the shut-off valve
located between the outlet of the
Pump Accessory and the garden
hose.
4. Turn your pump on allowing it to
pump out as much of the liquid in
the drum as possible. When you
notice that the pump is no longer
moving any water through the
hose and the speed of the motor
increases, turn the pump off.
ON/OFF
Switch
Closed
Position
Open
Position
Shut-off Valve
