Vacmaster EasyClean SCA0801, Руководство пользователя

Страница: 9 / 16

9
GB
2) Turn the quick release cord hooks to release the power cord (Fig. 8).
3) Plug the power cord into a power outlet.
WARNING: If any abnormality/failure occurs, stop using the product immediately and
disconnect the power plug.
4) Press the power button to turn the carpet cleaner on (Fig. 9).
5) For spills, first collect any excess liquid before using water/solution. Place the cleaning nozzle
towards the front of the spill and slowly pull backwards over the area.
6) To dispense cleaning solution, hold the tool about 2.5 cm over the area to be cleaned. Squeeze
the spray trigger to release a mix of water and cleaning solution (Fig. 10).
7) Release the trigger and use the brush on the nozzle to agitate cleaning area by scrubbing.
8) To lift away the stain, tilt the nozzle to make contact with surface and pull the tool backward
slowly to vacuum up excess dirty liquids. Repeat as necessary (Fig. 11).
NOTE:
Ensure the nozzle is in contact with the surface, over or under tilting may result in poor pick
up.
9) Once you have completed cleaning, press the power button and unplug the power cord.
CAUTION: THERMAL PROTECTOR
This carpet cleaner is equipped with thermal protector which automatically protects the
machine should it overheat. When the thermal protector activates, the attached nozzle will
stop spraying.
To reset thermal protector: Turn the carpet cleaner off and unplug the power cord from the
outlet to allow the carpet cleaner to cool for approximately 30 minutes.
Empty the dirty water tank and check for any obstructions if necessary.
3. Emptying Dirty Water Tank
WARNING: Always unplug power cord from electrical outlet before performing any service
on carpet cleaner.
Empty the dirty water tank when the dirty liquid reaches the "Max Fill" line and there is a loss in
suction. During normal use, debris may accumulate in the dirty water tank. To keep the carpet
cleaner functioning properly, rinse out the dirty water tank with clean water after each use and
leave to air dry before refitting.
1) Remove the dirty water tank from the side of the unit (Fig. 12).
2) Release the dirty water tank cover to open (Fig. 13).
3) Empty the tank into a sink or toilet. Rinse the tank thoroughly with clean water. Allow the tank to
air dry before reinstalling. DO NOT wash in the dishwasher. DO NOT install damp.
4) Close the tank cover and secure the release latch.
5) Reinstall the dirty water tank back into the unit.
WARNING: The motor noise changes to a higher pitch when the dirty water tank is full
or blocked. Stop the vacuum immediately and empty the dirty water tank.