1
CAUTION
THE PREAMPLIFIER AND POWER SUPPLY CONTAIN POTENTIALLY LETHAL VOLTAGES, AND
TUBES THAT BECOME HOT IN USE.
NEVER OPERATE THE PREAMPLIFIER OR POWER SUPPLY WITH THE COVERS REMOVED.
DO NOT REMOVE THE CHASSIS COVERS EXCEPT TO CHANGE TUBES OR LIGHT BULBS.
BEFORE OPENING A CHASSIS TO CHANGE TUBES OR LAMPS, DISCONNECT THE POWER
SUPPLY FROM AC POWER AND THE AUDIO CHASSIS FROM ALL OTHER COMPONENTS.
ALLOW IT TO SIT TURNED OFF FOR 30 MINUTES BEFORE REMOVING THE COVER. REPLACE
COVER AND SECURELY ATTACH BEFORE RECONNECTING AND OPERATING
DO NOT OPERATE THE UNITS IF THEY ARE WET.
VACUUM TUBES BECOME
HOT
ENOUGH TO CAUSE SERIOUS BURNS. NEVER TOUCH A TUBE
WHEN THE UNIT IS ON. IT MAY TAKE SEVERAL MINUTES FOR THE TUBES TO COOL DOWN
AFTER THE UNIT IS SWITCHED OFF. IT IS STRONGLY RECOMMENDED THAT THE TUBE COVERS
BE LEFT IN PLACE AT ALL TIMES.
THE AMPLIFIER AND POWER SUPPLY ARE
HEAVY
. IT IS ADVISABLE TO HAVE ASSISTANCE IN
UNPACKING, MOVING, AND SETTING UP. BE SURE TO USE PROPER LIFTING TECHNIQUES TO
AVOID BACK STRAIN AND INJURY. BE CERTAIN TO INSTALL IT IN A SECURE LOCATION FROM
WHICH IT CAN NOT FALL OR TIP OVER.
CONTENTS
Introduction
Installation
Inputs (back panel)
Outputs & Grounding Switch (back panel)
Operation
Fuses
Front Panel Controls
Remote Control
Replacement of Tubes
Care of Chassis
A Word About Tubes In General / Locating a Defective Tube
Warranty / Registration Form
