Pour it evenly on each side avoiding
the Coupling.
Lightly but evenly sand the mating
sides of the Hull flange and Deck
flange. Apply a bead of CA around
the flange of the hull. Place the
three paper clips as shown.
151
153
154
155
156
Arrange the ballast with a paper clip
with a bend at the end to reach under
the Coupling and Prop Shaft .
Cut 2 pieces of Hook & Loop. Stick
them to the front ballast as shown.
157
158
After it is fully cured, overnight,
remove the plastic bag from the
front ballast.
159
160
161
17
162
Bend 3 paper clips as shown. They
will keep the stern of the Deck from
sticking to the Hull too soon.
152
Remove the Coupling cover. While
the epoxy is still wet, check the
arrangement of the front ballast.
Cut the corner of the bag and
squeeze the ballast into the stern.
Arrange the 20 clips around the Hull
evenly. Practice clamping the Deck
to the Hull. Start at the bow and...
Arrange the ballast evenly on each
side, with a open gap under the
Coupling and Prop Shaft end.
Peel off the paper tape and stick the
ballast into the bow. It can now be
removed easier to adjust its weight.
work your way rearward. Don’t
clamp the stern until last. If you
clamp the front and back ends, the
middle will not meet.
Glue the Deck to the Hull
