![background image](http://html1.mh-extra.com/html/v2/wes-adi/wes-adi_instruction-manual_3130531011.webp)
E
N
G
L
IS
H
11
BASE UNIT INSTALLATION
PLEASE NOTE: disconnect the power to the main control unit prior to inserting the WES-ADI device
1.
Insert the WES-ADI module into the specific connector.
2.
Power up the control unit and ensure that the green LED on the base unit is flashing normally after a few seconds. If the red LED
remains on, this means the base has already been configured; it is necessary to delete the old configuration (see the section on
RESETTING THE BASE UNIT CONFIGURATION)
NOTE: when the device is powered up, up to 15 seconds may be required before the connection with all sensors is
re-established. The system is ready for use when the LEDs for all the sensors are flashing at the scanning frequency set.
L1 -
GREEN LED
L2 -
RED LED
L3 -
YELLOW LED
POSITION 1
POSITION 2
Содержание WES-ADI
