E
N
G
L
IS
H
PARAMETER
VALUE
DESCRIPTION
DEFAULT MEMO
r L
RELAY OUTPUT SELECTION
It enables the user to select one of the four relay outputs available: the
transmitters that are about to be saved subsequently will be associated to the
relay selected.
1
1
Relay output 1
2
Relay output 2
3
Relay output 3
4
Relay output 4
Fun
FUNCTIONS
: It enables the user to select one of the following functions
Mon
Mon
MONOSTABILE : it activates the corresponding relay through the time of TX
transmission. When the transmission stops, the relay goes automatically off.
biS
BISTABILE : it activates the corresponding relay on the first TX transmission. The
relay goes off on the second transmission
t iM
1 ” - 7’30”
TIMER : Transmitter transmission activates the corresponding relay that is
disabled automatically after a time that can be set from 1.0” to 7’30 with the
following intermediary steps: 1.0” - 2.0” - 3.0” - 4.0” - 5.0” - 6.0” - 7.0” -
8.0” - 9.0” - 10.0” - 11.0” - 12.0” - 13.0” - 14.0” - 15.0” - 30.0” - 1’00 -
1’30 - 2’00 - 2’30 - 3’00 - 3’30 - 4’00 - 4’30 - 5’00 - 5’30 - 6’00 - 6’30 - 7’00
- 7’30
t EL
0 - 1 007
TRANSMITTERS (save and delete)
To memorize
the transmitters proceed as follows:
1.
When on display is shown
t EL
press the MENU key:
on display is shown the memory cell
0000
NOTE:
the occupied memory cells are displayed discontinuously
2.
Should you intend to save the new transmitter into a specific memory cell,
select the desired cell and proceed. If no specific cell was selected, the
transmitter is memorized in the first cell available.
3.
Send data with the transmitter key that you intend to save in the memory:
the memory cell in which the new transmitter was saved is flashing on
display
4.
Send data with the other keys to be memorized or with other transmitters:
the occupied memory cell is flashing on display
To delete
the transmitters saved in the memory, proceed as follows:
1.
Select the memory cell to be deleted: the cell is flashing on display
2.
Hold the MENU key pressed until the cell is displayed steadily
CLt
DELETE ALL
This menu enables deleting all transmitters saved in the memory
no
no
Deletion is not completed
Si
Deletion in progress: on display is shown
CLr
until the operation is completed
r L C
ROLLING CODE mode
no
no
ROLLING CODE mode disabled
Si
ROLLING CODE mode enabled
End
Exit the programming menu
no
no
Do not exit the programming menu
Si
Exits the programming menu by storing the parameters set
