19
If you wish to make contact with us due to a
malfunction or in connection with an order,
please always quote the serial number (SN)
and the name of your device. Please enter
these data here and on the service sticker
delivered with the device (stick this to a highly
visible place or in your telephone diary).
FN
Appliance
- You can find these data on the certificate
of guarantee or on the original receipt, or on
the identification label on your device. The
identification label can be found to the left of
the left vegetable tray.
In the event of malfunctions please call
V-ZUG AG's local service centre on the
freephone
telephone number 0800 850 850
To avoid unnecessary fault reports, please
check the power supply is working properly
(Has the plug been plugged in? Is the fuse
intact?) before requesting a service technician.
Queries, orders, service agreement
For queries and problems of an administrative
or technical nature, as well as to order spare
parts and accessories, please contact the
head
office in Zug directly,
Tel. 041/767 67 67.
At the end of the guarantee year, you have
the option to conclude a service agreement
for the maintenance of all our products. We
will be happy to send you the corresponding
documents.
• Install the appliance away from heat sources.
Installation in a warm room, in direct sunlight
or near a heat source (radiator, oven)
increases energy consumption and should
be avoided.
• If this is unavoidable, please observe the
following minimum distances:
- 30 cm away from coal and oil ranges;
- 3 cm from electric and/or gas cookers.
• Mount the spacers (if supplied) on the rear
panel of the condenser behind the appliance.
• Position in a dry and well-ventilated location
and, if necessary, level using the front feet.
• Clean the inside of the appliance.
• Install the supplied accessories.
Electrical connection
• The electrical connections must be made
in compliance with local regulations.
• The voltage and power draw data are
specified on the type plate inside the
appliance.
• The appliance must be earthed by law.
The manufacturer shall not be held liable
for any injury to persons or animals or
for damage due to failure to observe the
above- mentioned regulations.
• If the plug does not fit in the socket, have it
replaced by a qualified expert.
• Do not use single or multi-way adapters or
extension cables.
Disconnecting the appliance from the mains
It must be possible to disconnect the appliance
from the mains either by unplugging the plug or
via the two-pole switch installed in front of the
socket.
REPAIR SERVICE
INSTALLATION
