V-ZUG Classic eco, Руководство по эксплуатации, Страница: 20 / 28

11 Tips and tricks
Malfunction Possible cause Solution
Temperature display
is flashing. ▪ The refrigerator compart-
ment temperature is 10 °C
higher than the set temper-
ature. ▸ Do not place warm foods right
next to the temperature sensor.
▸ If there is no warm food in the
appliance: call Customer Ser-
vices.
▪ There has been a power
failure. The flashing tem-
perature display shows the
temperature when the ap-
pliance is put back into
service. ▸ Touch any button.
– The set temperature is shown
in the temperature display.
▸ Check any refrigerated or frozen
food and discard if spoiled.
11 Tips and tricks
11.1 General information on using the appliance
▪ When closing an appliance door make sure that it forms a proper seal all the way
round. The self-closing hinges help keep it closed: the appliance doors close by them-
selves if the opening angle is between 20–30°.
▪ The electronic controller defrosts the refrigerator compartment once a day. A visible
layer of snow and ice on the rear wall of the refrigerator compartment is therefore nor-
mal.
▪ At high ambient temperatures, a significant amount of ice may form on the rear wall.
This is normal: due to the high humidity, more water condenses in the appliance and
ices up. Defrost the appliance manually only if necessary.
▪ The food must not come into contact with the rear wall of the refrigerator compartment
or it may freeze on. Additionally, water may enter the refrigerator compartment during
defrosting.
▪ It can take several hours for food and beverages to cool down from room temperature
to the temperature of the refrigerator compartment.
▪ Opening the door for long periods can cause a significant increase of the temperature
in the cooling zones of the appliance.
▪ Make sure that food or food items on the glass shelves do not tip over when the appli-
ance door is closed or prevent it from closing properly.
▪ Changing the temperature setting has no effect on the cooling rate. The fast cooling/
freezing functions (depending on model) increase the cooling rate.
20