V-ZUG Adorina V600, Инструкция по применению

Страница: 45 / 60

Troubleshooting
en
45
Fault Cause and troubleshooting
Tableware is not dry.
▶
Activate Extra Dry.
Tableware removed too early or drying process not
yet ended.
1.
Wait until the programme ends.
2.
Only remove tableware 30 minutes after the pro-
gramme has ended.
Rinse aid used has a limited drying performance.
▶
Use a name-brand rinse aid.
Eco products may have limited effectiveness.
Appliance door does not open automatically at the
end of the programme
▶
Adjust the appliance door as described in the in-
stallation instructions.
The door gap must be at least 70 mm - 100 mm.
Plastic tableware is
not dry. Not a fault. As plastic does not store heat so well, it
also does not dry as well.
▶
No remedial action possible.
Cutlery is not dry. Cutlery not arranged properly in the cutlery basket or
cutlery drawer.
Droplets can form on the cutlery contact points.
1.
Arrange cutlery individually where possible.
→
Page 30
2.
Avoid points of contact.
Appliance interior still
wet after wash cycle. Not a fault. The condensation drying principle causes
water droplets in the tub – they are indeed desirable
here. The moisture in the air condenses on the inside
walls, runs off and is pumped out.
No action required.
Remnants of food on
tableware. Tableware is placed too close together or basket is
overfilled.
1.
Arrange tableware with sufficient space in between.
The spray jets must reach the surfaces of the table-
ware.
2.
Avoid points of contact.
Spray arm rotation of the lower spray arm is blocked.
▶
Arrange tableware so that it does not obstruct
spray arm rotation.
Spray arm nozzles are blocked.
▶
Clean the Spray arms → Page 39 .
Filters are soiled.