V-ZUG Adorina V400, Инструкция по применению

Страница: 47 / 56

Troubleshooting
en
47
Fault Cause and troubleshooting
Rust spots on cutlery.
1.
Remove any spilled special salt from the tub.
2.
Screw the cap of the special salt dispenser on tight.
Detergent residue is
present in the deter-
gent dispenser or the
tablet collecting tray. Spray arms were blocked by tableware so detergent
was not rinsed out.
▶
Check that the spray arms are not blocked and can
rotate freely.
Detergent dispenser was damp when detergent was
added.
▶
Only add detergent to a detergent dispenser when
dry.
Excessive formation of
foam occurs. Hand washing-up liquid is present in dispenser for
rinse aid.
▶
Immediately add rinse aid to the dispenser.
→
"Adding rinse aid", Page 26
Rinse aid has been spilled.
▶
Remove the rinse aid with a cloth.
Detergent or appliance care product used causes ex-
cessive foaming.
▶
Change the brand of detergent.
Special salt refill indic-
ator lights up. Insufficient special salt.
▶
Add Special salt → Page 24 .
Sensor does not detect special salt tablets.
▶
Do not use special salt tablets.
Refill indicator for spe-
cial salt does not light
up. Water softening system is switched off.
▶
Set the water softening system.
→
"Setting the water softening system", Page 24
Refill indicator for
rinse aid lights up. Insufficient rinse aid.
1.
Add Rinse aid → Page 26 .
2.
Set the amount of rinse aid to be dispensed.
→
"Setting the amount of rinse aid", Page 27
Refill indicator for
rinse aid does not
light up. Rinse aid system is switched off.
▶
Set the amount of rinse aid to be dispensed.
→
"Setting the amount of rinse aid", Page 27
Water is left in the ap-
pliance at the end of
the programme. Filter system or area under the filters is blocked.
1.
Clean the Filters → Page 37 .
2.
Clean the Wastewater pump → Page 50 .
Programme has not yet ended.
▶
Wait until the programme ends or cancel the pro-
gramme with
Reset
.