Installation instructions
«Front loader» washing machine
One-family household
1064372-11
19/10/2022
1064372-11
3
Removing the transport locks
The transport locks 2 on the rear side have to be removed before using the appliance for the first time.
▸
Remove the hexagon head screws
1
of the transport locks
2
using a
10 mm ring or open-end wrench.
▸
Push the transport lock 2 up and out.
▸
Plug the holes with the rubber stoppers
3
.
Risk of soiling!
Failure to plug the holes with the rubber stoppers can result in error messages. Insert the rubber stoppers and prevent soiling
in the appliance.
Preparing the niche
Do not install in closed niches or in cabinets with doors. If no programme selection is made, the appliance door
opens automatically after 5 minutes and this can cause damage to the washing machine door and/or the niche door.
V-ZUG accepts no responsibility for any bacteria/germs and odours that form or any damage that may arise as a result.
B
C
≥605
≥860
≥5
≥45
≥5
1
2
B
4
3
B
5
3
Niche variant a)
Niche variant b)
B
Niche depth
≥605
≥645
C
Installation offset
≥50
≥83
▸
Determine niche depth
B
based on the niche variants.
▸
Provide an opening
1
on the left or right for connections and a fresh air supply (≥100 mm × 100 mm).
▸
Centre the installation plate
2
in the niche.
▸
Observe the distance from the installation plate to the back wall and the side walls.
▸
Observe installation offset
C
for installation plate.
▸
Check for underfloor heating.
▸
Fasten installation plate
2
to the Fastening down the installation plate (see page 4).
▸
Slide the appliance in.
–
Niche variant a): Niche front
3
and appliance front
4
are flush.
–
Niche variant b): Niche front
3
and appliance door
5
are flush.