REPLACEMENT PARTS
The following repacement parts may be ordered by calling our
customer service department at (0) 1522 515767.
Spray Nozzle............................................................................................................T25.0214
Inlet Plug...............................................................................................................B14.9191M
Spinner Body For H1.007 Cleaner (H.DUTY) .....................................................H1.007SKIT
Castor.................................................................................................................VT85790030
Fig. 5
USING THE SURFACE CLEANER
See Figure 5.
Attach the high pressure hose of your pressure washer to the
inlet plug on the surface cleaner’s spray gun.
Connect the garden hose to your pressure washer and start the
pressure washer as described in your pressure washer manual.
Walk slowly behind the cleaning deck, cleaning as you go.
NOTE:
If striping or swirling occurs, slow your pace. If
striping
or swirling continues, the surface cleaner skirt
bristles may be
worn and in need of replacement.
CAUTION:
Striking any raised obstacle while using the surface cleaner
will damage the unit. If contact does occur and causes
vibration when operating the pressure washer, stop and
replace the spray bar. Continuing to operate the unit without
replacing the spray bar could result in serious injury or
damage to the unit.
NOTE:
See figure 6 for the location of the spray bar
.
NOZZLE MAINTENANCE
See Figure 6.
Turn off the pressure washer and shut off the water supply.
With the surface cleaner on the ground, pull trigger to release
water pressure.
Disconnect surface cleaner from high pressure hose.
Using a wrench (not provided), remove the nozzle from the
spray bar.
NOTE:
Never point the spray bar at your face.
Using a straightened paper clip or nozzle cleaning tool (not
provided), free any foreign materials clogging or restricting the
nozzle.
Using a garden hose,
flush
debris out of nozzle by back
flushing
(running the water through the nozzle backwards or
from the outside to the inside).
Reconnect the nozzle to the spray bar and tighten securely.
After tightening, make sure the nozzle opening is pointed in the
same direction as the spray bar as shown in figure 4.
Reconnect the high pressure hose to the spray wand.
Turn on the water supply and start the pressure washer.
Excessive pump pressure (a pulsing sensation felt while
squeezing the trigger) may be the result of a clogged or dirty
nozzle.
SPRAY
BAR
NOZZLE
STRAIGHTENED
PAPER CLIP
Fig. 6
UK Head Office:
+44 (0) 1522 515767
V-TÜF
Fenco Group Ltd T/A V-TUF Till Bridge Lane
| Scampton |LN1 2SX
E-mail: [email protected]
Web: www.v-tuf.com
Trigger For Surface Cleaner....................................................................................VTSC119
Rotor Arm For H1.006.............................................................................................VTSC145
CASTOR WHEEL - Without Bracket Fits H1.006 & H1.007....................................VTSC102
SURFACE CLEANER - CASTOR WHEEL BRACKET Fits H1.006 & H1.007........VTSC103
SURFACE CLEANER - SPINNER BODY for H1.006 & H1.007 .........................H1.006SKIT
