DE35-ST Operating Instructions
D292469I
19
System Alignment: DE35
NOTE:
For DE35-300 alignment, proceed to the next section.
After the System has been assembled it must be aligned. The Pickup tip, Eject needle
and the Camera must be properly aligned for the system to properly pick and place die.
1.
Turn on the power and allow the system to reset, (30-40 seconds).
a.
If the error message,
Frame holder open, please close to continue
is
displayed, check the micro switch on the holder and/or the plug in the
connector.
b.
When the LCD displays
To resume, press the Yes key
, press
YES.
The
system will continue resetting.
2.
On the DE35 ST keyboard, select
Single Step
.
a.
The LCD should display
Teach Step Fine or Coarse
in upper left corner
and “Pickup Clear” in the upper right corner.
b.
The second line indicates what will occur next, when the foot switch is
depressed:
Turn on Tape Vacuum
3.
Use the DES to move the Wafer Holder until the die are out of the way and bare
tape is over the Eject Head.
4.
Press the Foot Switch until the Pickup Arm is over the Eject Stage, and the LCD
reads
Go Down To Pick Height
5.
Press the Foot Pedal once more to move the Pickup Head down to pick height. If
using a Vespel tip, tap the tip lightly down on the tape surface.
6.
Press the
NO
key to terminate the cycle. The Arm will move to the right to the
Wait Position. A circular mark should now be visible on the tape.
Содержание Royce DE35-ST
