1. Open the protective cover (4) and push the micro plug
(a) into micro socket (6).
2. Plug the adapter into a suitable mains outlet. Do not use
an extension cord.
3. When the battery is loaded, three LED indicators (7) all
illumine (Red light, yellow light and green light light up in
sequence).
NOTE:
Reset the protective cover after full charge which to
avoid water enter. (Refer to Fig. 2)
NOTE:
The LED indicator only will show red that means it‘s
batteries will soon run out and need to recharge.
NOTE:
Don’t turn the work light on/ use USB while
charging.
• To reduce the risk of injury, user must read and understand instruction manual.
• Always make sure the work light is off and complete cool before attempting to clean it.
CHARGING THE WORK LIGHT
The USB DC 5V 1A output socket (8) can use for
all kinds of device which can be charged by USB
cord (b), such as mobile phone, MP3/MP4,
Bluetooth headset etc.
NOTE: The USB output will stop output
automatically if the total working current of the
total connected device exceed the limit.
SWITCH ON/OFF AND LUMEN ADJUSTMENT (See Fig. 2)
The work light is equipped with an ON/OFF switch with mode function (8) locate on the back side of the
work light.
The LED work light’s brightness is adjustable.
With press ON/OFF switch (8): 1st press: 100% brightness; 2nd press: 50% brightness; 3rd press: SOS
flashing; 4th press: OFF.
Discharging time:
About 3 hours for 100% brightness;
About 5 hours for 40% brightness;
USB OUTPUT
OPERATION
WARNING!
Fig. 5
Fig. 4
