Remove the 3 screws (21) keeping the washers, remove the mechanism unit
(20a) and the coupling pin (14);
Take care to position the new wear pad (10a) correctly, if necessary replace
also the screws;
Fit the coupling pin (14) and the mechanism unit (20a) (see point 3 in chapter
5.2 REPLACEMENT OF THE MECHANISM UNIT AND THE COUPLING PIN, page
22/32).
Torque for the screws of the wear pad (10a) 3 Nm
1)
3)
4)
ATTENTION: Make sure that the coupling is closed, ie. the coupling pin
(14) is down.
N
O
T
E
5.5 REPLACEMENT OF THE WEAR PAD OF THE LOWER BUSH
2)
Loosen the 2 screws of the worn wear pad (10a) (see chapter 7
DISPOSAL, page 30/32), remove and replace it;
V . O
RA
ND
I
L
10a
REV. 00
CHAP. 5
PAG.
25/32
DRAWBAR COUPLING E 40
INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
Содержание E 40
Страница 32: ......
