Version 12.08.2016
VL2-RLINK
P
a
g
e
8
2.3.
Connecting video-interface and CAN-Box
The CAN-Bus Box reads digital signals from the CAN-bus and converts them for the video-
interface. ACC +12V max. 0.5A (red of 6pin) and reverse gear +12V max. 0.5A (green of 6pin)
constant signal. Video-source switching (white of 6pin) as +12V impulse.
Connect black female 4pin Micro-Fit connector of PNP Can/Power Cable to the 4pin
Micro-Fit connector of the CAN-box.
Note:
Check LEDs on CAN-box after reconnecting the battery, two must be on.
Connect white female 6pin Molex connector of the 6pin to 8pin cable to the male
6pin Molex connector of the video-interface.
Connect black female 8pin Micro-Fit connector of the 6pin to 8pin cable to male 8pin
Micro-Fit connector of the CAN-box.
Note:
Check LEDs on video-interface after reconnecting the battery, one must be on.
Note:
The CAN-box is not compatible to all vehicles. If the CAN-box does not deliver ACC to
pin2 of the video-interface or blocks the vehicle CAN, it is possible to install without CAN-
box. In this case see also note in chapter after-market rear-view camera, how the inteface
without CAN-Box is supposed to be connected.
