Version 07.04.2011
VL2-MMI2G
P
a
g
e
5
1.3.2.
Rear-view camera settings (dip 5)
Depending on whether no camera, after-market camera or factory camera shall be used, dip
5 must use different settings.
If set to OFF, the interface switches to factory LVDS picture
when the reverse gear is engaged to display factory rear-view
camera or factory PDC picture. The green wire of the video-
interface’s 6pin power connector must be connected to reverse
light (+12V of reverse light signal) by using a relay, ONLY if
camera shall is (to be) installed.
2.
Installation
Switch off ignition and disconnect the vehicle’s battery! The interface needs a
permanent 12V source. If according to factory rules disconnecting the battery
is to be avoided, it is usually sufficient to put the vehicle is sleep-mode. In
case the sleep-mode does not show success, disconnect the battery with a
resistor lead.
If power source is not taken directly from the battery, the connection has to be
checked for being start-up proven and permanent.
2.1.
Place of installation
The Interface has to be installed into the LVDS leads between monitor control-box and
monitor. The monitor control box is located at A6, A8 and Q7 behind the dash board, at A4
and A5 behind the air-conditioning control panel.
Rear-view
camera type
Dip 5
None
OFF
Factory
OFF
After-market
ON
