Version 28.07.2015
VL2-LR12-TS
P
a
g
e
6
1.4.
Dip-switch settings of the CAN-box
With the CAN-boxes dip-switches it is possible to select vehicle/
head-unit the interface is to be installed in.
Dip position down is ON and position up is OFF.
Vehicle/Navigation
Dip 1
Dip 2
Dip 3
Dip 4
Jaguar
OFF
OFF
OFF
ON
Land Rover
OFF
OFF
ON
OFF
LR Range Rover Evoque
OFF
OFF
ON
ON
After each change of the dip switch settings you have to execute a power reset of the CAN-
box!
2.
Installation
Switch off ignition and disconnect the vehicle’s battery! The interface needs a permanent
12V source. If according to factory rules disconnecting the battery is to be avoided, it is
usually sufficient to put the vehicle is sleep-mode. In case the sleep-mode does not show
success, disconnect the battery with a resistor lead.
If power source is not taken directly from the battery, the connection has to be checked
for being start-up proven and permanent.
2.1.
Place of installation
The interface is installed on the backside of the vehicle’s monitor. The external daughter PCB
is plugged in the flex cable between panel-board and main-panel of the factory monitor.
Therefore, the monitor must be removed and the body must be opened.
