Version 26.04.2021
HW: 16(V65)
CI-VL2-RTI11-5
P
a
g
e
10
2.5.
Connection - picture signal cable
Unclip the original copper coloured 50pin ribbon cable from the 50pin ribboncable
base of the monitor‘s mainboard and connect it to the 50pin ribbon cable base on
the top-side of the daughter PCB and clip it in again.
Connect the 50pin ribbon cable which is pre-mounted on the bottom of the daughter
PCB to the previously become free 50pin ribbon cable base on the monitor’s
mainboard and clip it in place.
Secure the daughter PCB to the monitor‘s mainboard, using the original screw.
Connect the daughter PCB’s long pre-connected 50pin ribbon cable to the 50pin
ribbon cable base of the video interface.
2.5.1.
Connection - Warning notes, concerning the installation of ribbon cables:
1) The contacting ends of ribbon cables always have to be installed in a straight and
precise 180° position to the connector. Each deviation from a perfect contact position will
curse faulty contact and even danger of short circuit
2) The ribbon cable’s contacting side always has to correspond to the contacting side of
the connector, concerning the mounting position.
