Version 17.02.2020
HW 16-(V65)
CI-VL2-NG4-HU
P
a
g
e
7
1.4.4.
Monitor selection (dip 7-8)
Dip 7 and 8 are for monitor-specific video settings which cannot be predicted as even within
the same head-unit version, the monitor specifications may vary. It is necessary to try all
possible combinations (both OFF, both ON, 7 OFF and 8 ON, 7 ON and 8 OFF) - while a
working video source is connected to the chosen input of the interface - to see which
combination gives the best picture quality and size (some may give no picture). It is possible
to first hot plug through the dip combinations, but if you do not experience any change of
picture after trying all 4 options, retry and disconnected the 6pin power plug of the video-
box between every change of the dip setting.
1.5.
Dip-switch settings of the CAN-box
With the CAN-boxes dip-switches it is possible to select vehicle/
head-unit the interface is to be installed in.
Dip position down is ON and position up is OFF.
Vehicle/Navigation
Dip 1
Dip 2
Dip 3
Dip 4
Citroen C5
ON
OFF
OFF
OFF
Peugeot 508
OFF
OFF
OFF
OFF
After each change of the dip switch settings you have to execute a power reset of the CAN-
box!
*Note:
No function of CAN-box in Alfa Romeo Giulietta, Citroen C3, Maseati, Peugeot 3008
und 5008 vehicles!
2.
Installation
Switch off ignition and disconnect the vehicle’s battery! The interface needs a permanent
12V source. If according to factory rules disconnecting the battery is to be avoided, it is
usually sufficient to put the vehicle is sleep-mode. In case the sleep-mode does not show
success, disconnect the battery with a resistor lead.
If power source is not taken directly from the battery, the connection has to be checked
for being start-up proven and permanent.
2.1.
Place of installation
The interface is installed at the
rear of head-unit
.
