Version 28.07.2015
CI-VL2-CONCERT
P
a
g
e
13
2.7.
Picture settings
After installing the sources the picture settings can be changed using a pen on the buttons of
the video interface. Press the MENU button to open settings menu on the OSD and to switch
to the next setting. UP and DOWN change the corresponding values. The buttons are
embedded in the housing to avoid accidental changes during or after installation.
The following settings are available:
Brightness
Contrast
Saturation
Position H (horizontal)
Position V (vertical)
3.
Interface operation
3.1.
By MODE button of the steering wheel
The MODE button of the steering wheel can be used to execute interface functions.
Press MODE
button
of the steering wheel for
about 3 seconds
to switch the video source.
Each press will switch to the next enabled input. If all inputs are enabled the order is:
Factory video
RGB-in
video IN1
video IN2
factory video
…
Inputs which are not enabled are skipped. If the audio cable is connected, when switching
from video IN1 to video IN2, also the sound will be switched.
Note:
The white wire of the 6pin to 8pin cable can be used with a +5-12V pulse to switch the
video-sources alternatively.
3.2.
By keypad
Alternatively or additionally to the MODE button the interface’s keypad can be used to
execute interface functions.