2
V1.06
VG-6727 Digital Control Interface
Installation and Operation Manual V1.06
Installation and Operation Manual V1.04
Mounting:
Warning: Please disconnect the loop power in order to avoid control panel broken by short circuit when
mounting Base.
1.Make sure the mounting direction mark
“
↑
” on Base is upwards .
2. Install the base stable by using two screws, and connect all cables in accordance with wiring details.
3. Install the control interface body on to base directly.
4.Control interface Mounting showing in Fig.2.
Fig.2
Terminal Connection
1.
1, 2:
Connecting with Detection loop (Non-polarized) L+;L-
2.
6, 7:
NO; CNormally Open Contact.
3.
7, 8:
NC; C Normally Close Contact.
4.
9, 10:
Connecting with input signal contact.
5.Loop wiring is shown in Fig.3
6.Use RSV 1.0mm
2
or above fire cable for each terminal.Laid through metal tube(cable sink) or PVC tube.
Mounting direction
Fig.3
