V-fit FC2995-UK, Руководство пользователя

Страница: 17 / 24

Assembly
2
Note
Do NOT tighten the Handlebar
Upright at this stage.
The Tension Control Knob (71)
must be set at position "1".
A-1.Hold the Tension Cable-Lower (52) below the metal bracket. Guide the lower part of
the inner cable of the Tension Cable-Upper (68) into the formed metal loop on the
inner cable of the Tension Cable.
A-2.Still holding the Tension Cable-Lower (52), pull the Tension Control Knob(71) inner
cable away from the Metal Bracket (you will notice some resistance at this
stage) and guide the inner cable through the open slot in the metal bracket.
A-3. Slowly release the tension on the upper cable and guide it carefully into the hole
in the top of the metal bracket.
A-4. Complete the fitting as shown and if necessary, close the open section of the metal
bracket slightly with a pair of pliers as this will help to retain the cables. Connect the
lower part of the Exercise Monitor Sensor Wire (53) to the Exercise Monitor Link
Wire (69), ensuring a tight connection. Carefully lower the Handlebar Upright (70)
onto the Main Frame (66), then loosely fit the upper holes by 4 x M8 x 20mm Allen
Bolts (67), 4 x M8 Spring Washers (6) and 4 x M8 Curved Washers ( 5) as shown
below.
69
66
52
53
53
5
6
67
5
67
6
68 69
69
70
71
A-1
A-2
A-3
A-4
68
52
Page 1 7