User Manual
RONDA
®
2600 The Vac for Factories and Warehouses
21
V. BRØNDUM A/S
Replacing the Filters
In General
When replacing the filter, the necessary precautions to protect the environment and the respiratory passages of
the operator must be taken. This protection must be carried out with due regard to the nature of the use to which
the vacuum cleaner has been put and to whatever hazard is posed by the dust on the surface of the filter.
Check and Replacement of the Multi-Tube Filter
The multi-tube filter is made of a very robust filter material and has a very long life span. However, the surface of
the filter will gradually be worn by all the large and small particles, which are held back. Consequently, the filter
must be checked for holes and fissures on a regular basis. Even small holes in the filter material will allow
particles to penetrate the filter and continue through the filter and the motor, unless the appliance is equipped
with a HEPA filter.
Loosen the container clips of the motor top and remove the motor
top.
Place the motor top on a dry, clean and flat surface.
Check the top surface of the multi-tube filter for dust particles. If
you can see dust particles there, it is a sign of a damaged and
worn multi-tube filter.
If the multi-tube filter is damaged, or if there are holes in surface of the
filter, the multi-tube filter must be replaced. If the multi-tube filter is replaced, the HEPA-filter should be replaced
at the same time. See the next page.
