V-Bro Products Garage Gator GGR125, Инструкция по установке и эксплуатации

Страница: 10 / 17

10
Step 4
Connect and install the spacer channel and spacer pulley bars
• Insert the flared end of a spacer channel bar onto the fixed bolt coming down from the
motor plate tab above the cable spools on the motor hoist. Attach a 6mm washer (L) and
a 6mm nut (Q) to the fixed bolt and tighten with the adjustable wrench until the spacer
channel bar is securely fastened to the motor hoist.
(SEE FIG. 4)
• Line up the hole in the end opposite the pulley of the spacer channel pulley bar (D) over
the hole in the spacer channel bar (C). Thread a 1/4” x 1/2” bolt (P) into the hole and
tighten with a ratchet or adjustable wrench until the spacer channel pulley bar is securely
fastened. (SEE FIG. 5)
• Press the spacer channel pulley bar flush with the ceiling and mark with a pencil where
the wood screws will be used to attach the bar to the joist. It is very important that the
wood screws are fastened to the center of the joist. Use the hole saw drill bit (U) or
cut away the drywall with a utility knife to obtain an unobstructed view of the width of the
joist so the exact center can easily be determined (covered ceilings only). It may be
necessary to reposition the spacer channel pulley bar and mark with a pencil where the
wood screws are to be fastened.
• Using a power drill with a 1/16” drill bit attached drill a pilot hole into the center of the
joist.
• Using the ratchet and 1/2” socket fasten a 3” lag bolt (K) into the joist until the spacer
channel pulley bar is securely fastened to the joist.