Page | 13
1. Copy the firmware update file (eg. Main.elf and
spec.bin) onto the SD card root directory (do not place
in any file)
2. Insert SD card into the camera
3. Push and hold UP arrow while turning camera to
SETUP mode
4. The blue LED on camera front will blink until the update
is finished.
5. The camera should automatically re-boot. If it does not
re-boot within 10 seconds of the blue LED turning off,
turn camera OFF and remove batteries to break power
connection.
6. Replace batteries and turn camera to SETUP mode
7.
Confirm new firmware version by checking ‘Camera
Information” (see instructions)
TROUBLESHOOTING
1.
The camera does not turn ON
i.
Ensure batteries are inserted properly with correct
polarity and fully charged. If possible test each battery
with battery tester. Approximately 1.7V for Lithium and
1.3V for NiMH is full power.
ii.
Ensure SD card is properly inserted and not in locked
position
iii.
Reset camera by removing batteries and SD card for
10 minutes
iv.
Cold temperature may decrease battery output
sufficiently to prevent camera from turning ON; check
batteries and ensure they are rated for cold
temperature
2.
Beeping Noise when camera turns ON
i.
Insert SD card
ii.
Ensure SD card is not locked
