Page 5/10
HI 1 - E Manual v1.1.0.doc, AR, 15.06.2011 Glauburgstraße 34 D-63683 Ortenberg
Änderungen vorbehalten / All data are subject to alteration. [email protected] www.uv-technik.com
Manual
3.2 Handling batteries
When inserting batteries / rechargeable batteries ensure that these are correctly polarized.
If the device will probably not be needed for a relatively long period of time or if the batteries
are empty, remove the batteries; this will prevent battery acid leaking onto the device and
damaging it.
Rechargeable batteries should be recharged as and when necessary.
You should never attempt to recharge an ordinary (non-rechargeable) battery; it may
explode !
Batteries / rechargeable batteries must never be short-circuited or thrown onto the fire.
Batteries / rechargeable batteries are special waste and must not be discarded together with
normal domestic waste.
4 Introduction
The HI 1 is equipped with a patented connector system. The intelligent connector offers decisive advantages when
connecting sensors and peripherals because all parameters are stored in an EEPROM located on the connector
itself; repeat programming is thus no longer necessary.
4.1 Function
The HI 1 measuring instrument has just one measuring input. For operation purposes the device incorporates a
large LCD display and a keypad.
4.2 Sensor programming
The measuring channels are programmed, completely and automatically, by the intelligent connectors.
5 Initial commissioning
1.
Connect sensor
to socket
M0
(1)
.
2.
Ensure that the power supply
is provided by 3 AA batteries;
3.
To switch ON
press key
ON
(3)
4.
Select measuring channels
by pressing key
M▲
(3), read out measured values (5e)
5.
Save the measured value
by pressing key
MEM
(3)
6.
Relative measuring
to a reference value by pressing key
CLR
(3)
Revert to normal measured value by pressing and holding down key
CLR
7.
Evaluating a measuring operation
Call up maximum / minimum values by pressing keys
MAX
/
MIN
(3)
To delete max. / min. value(s) press and hold down key
MAX
or
MIN
see