Ver.3
9. Place the front wheel. Wheel position is indifferent
since it has no right-left differences. Place the shaft
with quick release lever and adjust the wheel to set it
properly.
10.
Place the brake cable on the front wheel by
removing the black rubber to the left and try to fit it
with the bracket’s thinest part. Some strength and a
little patience is needed. To facilitate this, loosen the
tension cable with allen wrench no. 5, put every piece
in place, re-tension the cable and tighten the screw
once again. Ensure that the wheel rolls without being
touched by the brake pads and the brake lever has an
adequate roll.
11.
Place the pedals taking into account they have
R
ight and
L
eft position. The pedal on the right is
marked with the letter
R
and left with
L
. Screw them
properly with wrench no. 15. Remember all pedals are
screwed forward in order to prevent unscrewing
during pedalling.
12. Once the battery is charged you can put it in place. Very important: Remember to keep a copy of the battery
keys in a safe place and/or make a third copy. We have no extra replacement keys.
13. Put the saddle at a proper height for the rider. Tightly screw the mounting handle.
14. Inflate the wheels according to the pressure indicated on the tires
HIGHLY IMPORTANT:
It is better to keep the battery at a high level of charge. Do not wait for it to be completely discharged.
Even if you do not use the bike for two months, we recommend to fully charge the battery at least once.
Try not to expose the battery to extreme temperatures (below 10ºC or above 40 ºC).
¡Now it is time to enjoy your UUALK SUN’14!
Please, contact with Uualk team in case of any doubt.
www.uualk.com
