6
OPERATING INSTRUCTIONS
WARNING:
Inspect heater for damage which may have occurred during shipment. DO NOT operate if any damage is
noted. Return damaged heater to retailer or factory for repair or replacement.
1. Install heater to an overhead location (SEE INSTALLATION INSTRUCTIONS).
2. Plug heater into 120Volt, 60Hz. AC grounded plug. See "Important Instruction" at the beginning of this book.
3. Rotate heater to aim in desired direction.
CAUTION:
Do not rotate this heater while it is operating or hot. The cabinet can be very hot.
4. Do not aim heater at any surface closer than 3 feet.
5. Set Power Setting Indicator to the desired position by pulling the pull-cord continuously.
0
= Off Position
I
= Position 1: 750 Watts, One Element
II
= Position 2: 1500 Watts, Two Elements
III
= Position 3: 750 Watts, One Element with Light
VI
= Position 4: 1500 Watts, Two Elements with Light
REPLACING HALOGEN LAMP
This model heater features an exclusive, replaceable halogen lamp system. In the event that a halogen lamp in this
heater should break, burn-out or become inefficient, you can purchase replacement halogen lamps. Halogen lamps
(use only type G9, 120V., 60Hz., 25W) are available at most hardware and home center stores.
WARNING:
Replacement bulb rating must not exceed 25-watts.
NOTE:
Never touch Halogen lamp with bare hands. Oil residue from bare hands will cause lamp failure.
1. Unplug heater, then remove it from Mounting Bracket.
2. Open lampshade: Remove the screw located at the side of lampshade and open the lampshade.
3. Remove old lamp: Grasp the old lamp and carefully pull it out of the lamp holder.
4. Install new lamp: Install new lamp using clean cloth or gloves. Insert end of the lamp into the lamp holder.
5. Close lampshade and re-install screw. Snap heater onto properly installed mounting bracket before use.
MOUNTING ARM
Connect to
mounting bracket
ARM RELEASE BUTTON
Push button on both sides
to release heater from
mounting bracket
PULL CORD
To select power settings
POWER SETTING INDICATOR
Five positions:
0 = Off Position
I = Position 1: 750 Watts, One Element
II = Position 2: 1500 Watts, Two Elements
III = Position 3: 750 Watts, One Element with Light
VI = Position 4: 1500 Watts, Two Elements with Light
HALOGEN
LAMP
NOTE: MAXIMUM HEATER
ROTATION IS 90º
