4
INSTALLATION INSTRUCTIONS
OPERATING INSTRUCTIONS
HEATER INSTALLATION:
Always operate the heater in the upright position following all instructions and recommendations listed in this manual.
HEATER LOCATION:
Place the heater in the area of the room that is coldest.
HEATER CONNECTION:
Plug heater directly into 120-volt A.C., 60Hz wall outlet. Be sure plug fits tightly in outlet. A loose connection may
cause overheating and damage to the plug or heater.
NOTE:
To prevent overloading a circuit, do not plug the heater into a circuit that is servicing other electrical needs.
POWER INDICATOR:
This heater is equipped with a Power Indicator Light. The power light will illuminate when the
unit is plugged in to alert you that the unit has power.
TURNING HEATER ON:
To start the heater, turn the Power Control dial from OFF position to FAN, LOW, HIGH, or ECO-Setting. Then rotate
the Thermostat Control clockwise to the HIGH THERMOSTAT position as described below.
NOTE:
During the heaters initial use, you may experience a slight odor or smoking. This is the result of the heating
element fabrication protective coating “burning off”. This is normal and will go away after a few minutes of use.
POWER CONTROL DIAL:
This heater has 3 heat settings: ECO-Setting, HIGH, and LOW. Select the heat setting
that best meets your heating needs.
SETTING THERMOSTAT:
After heater has been turned on and the room has reached the desired temperature, slowly
rotate the THERMOSTAT CONTROL dial counterclockwise until the heater shuts off (you should hear a faint “click”).
By leaving the thermostat at this setting it will automatically maintain this temperature. To lower temperature, rotate
the knob further counterclockwise (towards the LOW position). To raise the temperature, rotate the thermostat knob
clockwise (towards the HIGH position).
TO OPERATE FAN ONLY:
Turn the power control dial to the FAN setting. Turn thermostat fully clockwise so the fan
will run continuously.
TURNING OFF
: Turn the power control dial to the OFF position before unplugging or plugging in the heater. Heater
should be unplugged when not in use.
OSCILLATION CONTROL
: You can control
the Oscillation feature on the heater by
pressing the OSCILLATION CONTROL switch
located at the base of the heater.
OSCILLATION
CONTROL SWITCH
POWER INDICATOR LIGHT
behind the safety grille
ECO
CONTROL PANEL
THERMOSTAT
CONTROL
POWER CONTROL and
FAN ONLY DIAL
