OPERATING INSTRUCTIONS
1. Place the product upright on a flat, level, stable, heat-resistant surface, and
then plug the power cord into a standard 120-volt electrical outlet.
2. Main Control Knob (Figure 1): Use this knob to set the heat setting:
"Fan" – Fan only (no heat)
"1,300 W" – Low heat setting
"1,500 W" – High heat setting
3. Turn the thermostat control knob clockwise to its maximum
range. The power indicator will illuminate, indicating the heater (A) is on.
4. Allow the product to operate until the ambient room temperature
reaches the desired comfort level.
5. Slowly turn the thermostat control knob counterclockwise until the product
turns off. The product will cycle on and off to maintain the setting.
6. To adjust the thermostat, turn the thermostat control knob toward high
to increase the set ambient temperature and toward low to decrease it.
7. To activate anti-freeze setting function, set the thermostat on " " and the heat switch
to 1,500 W. The unit will operate automatically when the surrounding temperature
becomes close to freezing. Operation will continue until the immediate surrounding temperature rise.
8. Turn off the product by rotating the main control knob to the "OFF" position, and then unplug the
product from the electrical outlet.
WARNING:
Always unplug the product when it will be left unattended or not in use.
CARE AND MAINTENANCE
WARNING:
Do not attempt to disassemble this product for any reason, as incorrect re-assembly could
cause a risk of fire or electric shock. Only qualified service personnel should perform any servicing
.
WARNING:
Always unplug the product from the electrical outlet and allow it to cool before cleaning or
storing it.
NOTICE: This product is permanently lubricated at the factory before shipping and will not require
further lubrication for the life of the product.
• Clean only the exterior surface by wiping with a soft, damp cloth, and allow the product to dry
completely before storing or using. Dust can be removed from any vents using a small vacuum.
• To store, wind and secure the power cord using a twist tie or rubber band, and then place the product
in a cool, dry location.
WARNING:
Do not allow water or other liquids to enter the interior of the product.
NOTICE: Do not use abrasive cleaners/pads to clean the product.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
Your heater shuts off
unexpectedly or fails to
operate.
1. No electric power.
2. One of the safety features
may have activated to
prevent overheating,
including the tip-over
safety switch and thermal
overload protector.
1. Be sure the power cord is plugged
into a working electrical outlet.
2. a. Check your thermostat setting.
The heater may be off because
it has reached the desired
temperature setting.
b. Unplug the heater and wait 10
minutes for the unit to cool down.
After 10 minutes, plug the unit in
again and operate normally.
6
POWER
CAUTION
THERMOSTAT
LOW
HIGH
1
