9
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
The light will
not
illuminate.
1. The sensor may be detecting daylight or
other bright light source near the unit.
2. The SENSITIVITY may be set too low.
3. The battery is low or drained.
4. The solar panel plug isn't properly
connected.
5. The battery plug isn't properly connected.
1. Reposition the installation
place to avoid other lighting
source.
2. Rotate the SENSITIVITY
knob clockwise in order to
make the detector more
sensitive to motion.
3. To charge the battery fully.
4. Make sure the solar panel
plug is fully inserted.
5. Make certain the battery
plug is connected inside
the battery compartment.
The battery
does not
fully charge.
1.
If there is frequent activity from dusk to
dawn or continuous overcast days, the
solar panel may not convert sufficient
ambient daylight to recharge the battery
sufficiently.
2.
There is no enough sunlight.
3.
There is dust and debris on the solar
panel.
4.
The cable of solar panel may be
damaged.
1. Avoid unnecessary activity.
2. Reposition solar panel to
receive more sunlight.
3. Clean dust and debris from
solar panel.
4. Make sure the solar panel
cable is not damaged.
The light
stays on
continuously.
1. The SENSITIVITY may be set too high.
2. There are other movements that trigger
the light.
1. Rotate the SENSITIVITY
knob counterclockwise in
order to make the detector
less sensitive to motion.
2. Avoid other movements may
trigger the light needlessly.
Motion is not
detected
within the
coverage
area.
1. The motion is directly towards the sensor.
2. The light may install at the place near air
conditioner, central heater, or hot air flow.
3. There is dust on motion sensor lens.
1. The sensor is more sensitive
to motion which is across the
detection field than directly
towards the sensor.
2. Avoid installing the light near
such place.
3. Clean the dust on the lens.
CARE AND MAINTENANCE
This LED motion-activated light provides
years
maintenance-free service with no bulbs to change.
Do not touch LED or open fixture housing.
To clean, turn OFF all power to circuit and clean surfaces with a mild, non-abrasive cleaner.
It will be necessary to periodically clean the solar panel with soft wet cloth.
