Notice
连 接 接 口
连接接口
Trouble Shooting
Please find the following solution when the device doesn't work
连接接口
RJ
45
Making
Method
p
in
color
white/green
green
blue
white/orange
white/blue
white/brown
orange
brown
1
2
3
4
5
6
7
8
pin
color
1
2
3
4
5
6
7
8
white/green
green
blue
white/orange
white/blue
white/brown
orange
brown
EIA/TIA 568A
EIA/TIA 568B
●
When choose RJ-45 make sure if one end is EIA/TIA568A,the other end should also be EIA/TIA568A.
●
When choose RJ-45 make sure if one end is EIA/TIA568B,the other end should also be EIA/TIA568B.
Instruments to be used: wire crimper, network tester. Wire sequence of RJ45 plug
should conform with EIA/TIA568A or 568B.
1
)
Shuck off about 2cm long the insulating layer, and bar the 4 pairs UTP cable;
2
)
Depart the 4 pairs UTP cable and straighten them;
3
)
Line up the 8 pieces of cables per EIA/TIA 568A or 568B;
4
)
Cut out 1.5 cm cable wrap and leave the bare wire;
)
Plug 8 cables into RJ45 plug, make sure each cable is in each pin;
5
6
)
Then use wire crimper to crimp it;
7
)
Follow the 5 steps above to make the another end, following the same sequence of
the first plug
;
8
)
Using network tester to test the cable whether is working.
3
4
连接接口
Specification
Products are subject to change without prior notice.
Item
Description
Model
16-Port 10/100M PoE Switch
24-Port 10/100M PoE Switch
Downlink
Ports
16*10/100Base-T(PoE)
24*10/100Base-T(PoE)
Uplink
Ports
2*10/100/1000Base-T RJ45
Standards
IEEE 802.3,802.3u,IEEE802.3ab,IEEE802.3z,IEEE802.3x
Switching Capacity
7.2Gbps
8.8Gbps
Packet Forwarding Rate
5.2Mpps
6.4Mpps
Forwarding Modes
store and forward
Packet Buffer
2.75Mbits
MAC
Table
8k
PoE
Standard
802.3af/at(PSE)
PoE
Pin Assignment
1/2(+),3/6(-)
PoE Power Output
PoE(Single port)
≤30W(54V DC)
Total PoE Budget
≤135W
PoE(Single port)
≤30W(54V DC)
Total PoE Budget
≤
225W
Three Working Modes
Default
：
All of the ports
could
communicate
freely
.
VLAN: Port 1-16/24 are isolated respectively, but can communicate with
uplink ports, support PoE watchdog.
CCTV: The transmission distance can be extended to 250 meter, while link
speed of downlink ports 1~16/24 will be limited to 10Mbps(Uplink ports
keep 100Mbps). Support PoE watchdog.
Surge Immunity
Common mode 6KV, Execute standard: IEC61000-4-5
ESD Protection
Contact discharge 6K, Air discharge 8KV,
Execute standard: IEC61000-4-2
Input
Voltage
AC100~240; 50/60 Hz
Power Consumption
<10W
Operating Temperature
-
10
℃
~50
℃
Storage
Temperature
-
40
℃~
85
℃
Operating Humidity
5%~95% (Non
-
condensing)
Dimension (W*D*H)
294mm*180mm*44mm
440mm*180mm*44mm
Weight
2kg
2.32kg
16/24-Port10/100MbpsPoESwitchwith2Gigabit
UplinkPorts
Please confirm if the installation is correct.
Please confirm if the RJ-45 cable order is following the EIA/TIA568A or 568B
industry standards.
It can not exceed maximum 30 watts of each port.
Please replace the failed device with a normal one to check if the device is broken,
if the problem still exists, please contact the factory.
16/24-Port10/100MbpsPoESwitchwith2Gigabit
UplinkPorts
