11692017 Rev A
- 12 -
© 2009 UTC RETAIL
8. Attaching the RCD Head
Install the rear cover back onto the 3100 Series. Do not install the
rear cover screws and plugs at this time. Remove the RCD head
from the box and feed the RCD head's cable through installed
adapter and behind the handle on the chassis cover. Continue to
install the head onto the adapter, locking the adapter’s nub into
the middle of the 5 holes in the RCD pole adapter.
9. Connect to the COM Port
Lift up the rear door of 3100 Series. Obtain the cable with the 9-
pin serial plug from the RCD product box; plug it into the COM port
matching the port selected in the “Configuring the COM Ports”
section. The photo to the right shows the cable attached to the
COM2 jack. Secure the plug to the chassis using the two attached
locking screws. Connect the other end of this cable with the cable
from the RCD head; align the two plugs, press and lock them
together.
10. Testing the RCD
Finish configuring your 3100 Series POS Bundle (Steps 11-13 on
the following pages), then return here to test the RCD.
Turn on the 3100 Series. A bootup message (shown at right) will
appear on the RCD for about 2 seconds.
When at the Windows desktop, start HyperTerminal. Look on the
Start menu, All Programs
→
Accessories
→
Communications
→
HyperTerminal
If necessary, answer the question regarding default telnet
program.
