2 / 2
P/N 466-5414 • REV B • ISS 071217
Figure 3: Installing antenna(s)
2. For applications where the hub is permanently mounted
on a wall, create a hole to allow the antenna to drop down
the wall.
3. For applications where the hub is mounted on a desktop
stand, secure the antenna in a place that cannot be easily
moved by using the included adhesive strip.
Note:
Be sure to keep hub and cellular antennas away from
electrical devices such as appliances, routers, cables boxes,
as well as mirrors to optimize signal strength.
Commissioning the cellular module
To commission the module:
1. Once the cellular module is installed in the hub, it will
automatically start to try and find a cellular network.
2. When provisioning the system on the UltraSync Portal,
remember to select a Service Grade that includes Cellular.
Specifications
Voltage
5VDC (provided by panel)
Current
40 mA min / 750mA max at 9 V
External connector
Two MMCX
Dimensions (W × H ×
D)
97 x 31.5 x 20mm
Storage temperature
-34° to 60°C (-30° to 120°F)
Weight
190 g
Operating environment
Temperature
Relative humidity
0° to 49°C (32° to 120°F)
maximum 90% noncondensing
Regulatory information
Manufacturer
Placed on the market by:
UTC Fire & Security Americas Corporation, Inc.
3211 Progress Drive, Lincolnton, NC, 28092,
USA.
US/C compliance
FCCID: N7NHL7588
IC: 2417C-HL7588
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This class B digital apparatus complies with Canadian ICES-3B.
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada.
Caution: Any changes or modifications not expressly approved by the
party responsible for compliance to this equipment would void the
user’s authority to operate this device.
This Device complies with FCC & ISED radiation exposure limits.
This device complies with Industry Canada’s licence-exempt RSSs.
Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference
that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes :
1) l’appareil ne doit pas produire de brouillage;
2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
Contact information
For contact information, go to
www.utcfireandsecurity.com
or
www.interlogix.com
Customer support (US)
For customer support, contact
Interlogix Technical Support
Tel +1 855 286 8889 (Option 2)
[email protected]
www.interlogix.com
Copyright © 2017 UTC Fire & Security. All rights reserved.
