UTC Fire and Security Interlogix NX-4V2, Руководство пользователя

Страница: 11 / 21

NX-4V2 LED Keypad User Manual 7
Step 2 Enter your 4 or 6 digit user code to arm the system.
• The armed and exit lights will illuminate.
• You may now leave the building.
Arming your system in the “STAY mode”
STAY is used when the user is inside the premise and wants protection around
the perimeter. Listed below are the steps to arm in the STAY Mode:
Step 1 Close all protected doors and windows.
• Ready light must be on or flashing when all protected zones and sensors are
secure. Note: If any zones are bypassed, a sensor in that zone can be
violated without affecting the
ready light.
• The security system will not arm if the
ready light is not on or flashing.
• If the
power light is off, you have no AC power. Restore power if possible. If
not, contact your installing company for service.
Step 2 Enter your 4 or 6 digit user code.
• If the “Auto Bypass” is enabled, all interior zones will be bypassed if you do
not leave through a designated entry/exit door. If “Auto Bypass” is enabled,
omit step 3.
• When “Auto Instant” is enabled, if you do not leave through a designated
entry/exit door the instant light will illuminate indicating that the entry/exit
doors no longer have an entry delay. If an “Auto Instant” is enabled, omit step
4.
Step 3
• Press the [STAY] key.
• The
bypass light will illuminate indicating that all interior zones are bypassed.
(All interior devices will bypass automatically, giving the user freedom of
movement within the interior area.)
• For each interior zone bypassed, the corresponding
zone light will also
illuminate. If any zone(s) have been bypassed previously by the user, the
light(s) corresponding to the bypassed zone(s) will illuminate, alerting the user
that a zone(s) may be unprotected and can be faulted without an alarm.
• The
stay light will also illuminate. Note: normally, all entry/exit doors will be
delayed.
Step 4
• To change entry/exit to “Instant”, press the [STAY] key again.
• The
instant light will illuminate indicating that the entry/exit doors have no
delay.
• To change entry/exit to “Delayed”, press the [
STAY ] key again.